market is fully bullish and it makes higher high . now it it make new break of structure(BOS) and now wait for taken out IDM and tap on order block(OB) TELGRM - @akforextrade
Buying expected in Bank nifty At this order block Market still bullish
xauusd market changed to bullish trend now wait for order block for get enty
market is bullish side and inducement taken out so high is confirmed and tap on 1st O B then go to lower time frame 1H for entry and take entry on the basis CHoCH or flip entry module and if this does not hold the market then looking for sell side for next poi which is extreme.
SILVER market is in bearish trend and it taken out inducement and 1st order block is owrking and it give somereaction but if market goes higher high and tap on ENG LQD and sweep it then shift to 1 min time frame for confirmation and take entry. if market close above ENG LQD then wait for tap on extrrem OB then check confirmation at lower time frame and take entry...
market is bullish side so go for buy only and sell for short term if market tap on extrrem POI then go for buy side in lower time frame 1H is your lower time frame .
market is in bullish trend and finally market taken out inducement and now market wait for tap on 1st order block and give any reaction in lower time frame then go for buy side and if market faild to hold this level then go for sell side untill market tap on ENG LQD or extrrem OB
market structure is bullish and inducement taken out so high is confirmed and if 1st order block failed to hold the market then we have to take short time selling untill next ENG LQD or O B . minor gap between ENG LQD and OB so its valid.
this is chart analysis for weekly on EURUSD 1st scenario if market take inducement then take entry on 1st order block and take confirmation at 1min time frame then take entry. if market failed to hold 1st order block then wait for eng lqd taken out then go for sell. 2nd scenario if market sweep inducement then go to 1min time frame and take entry on the basis of...
its all about probability in smc most of the time first and last order block work after IDM & ENG LQD respectively . please use 1min time frame for entry to reduce your risk and increase your R:R ratio
My all entries on the basis of smc trading. i used session high low LQD sweep and Day high low LQD sweep for any question comment below
session sweep entry all target done smc trading vs retail trader
session high low act like liquidity and after liquidity sweep use entry criteriya for enty
when market tap on this OB then shift to 1min time frame for CHoCH and then take entry after geting OB in 1 min time frame
At the selling zone rejection candle appear then sell and if h4 candle close strongly bearish then hold for long at 1885
buy limit in this digram and follow for more SMC learning chart
as i said in my ideas that this orderblock and order flow are valid and this will work. now the result is you can see that it HIT 180 PIPS IN XAUUSD
my long trade now will going to be start so be carefully and watch full video to get entry point